Compatible Systems MicroRouter 900i Manual do Utilizador descarregar pdf (Página 45)

Section 6 - Work Holding - 45Microrouter CNC Machine User's Manual

6: Preparing the Microrouter Working Area

Although the vacuum table itself is supplied fully assembled, the

Microrouter must be prepared before the vacuum table can be used:

1) Ensure the microrouter floor is clean and free from any dust and

debris. This will help ensure a strong vacuum can be created

between the rubber gasket on the vacuum table and the

Microrouter floor.

2) Using a flat blade, lift and remove the plastic blanking cover from

the vacuum inlet hole, located in the centre of the Microrouter

floor. Take care not to damage any of the retaining prongs fitted

to the underside of the cover, during its removal. Do not leave

the plastic cover inside the Microrouter working area - store it

safely for refitting after machining has finished.

Vacuum

inlet hole in

Microrouter

working

area floor.

Remove the plastic cover fitted

to the vacuum inlet hole in the

centre of the Microrouter

working area floor..

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 93 94

Sem comentários

Compatible Systems MicroRouter 900i Manual do Utilizador Página 45