Compatible Systems MicroRouter 900i Manual do Utilizador descarregar pdf (Página 27)

Section 4 - CNC Machine Operation - 27Microrouter CNC Machine User's Manual

4: Switching the Microrouter On

Follow these instructions to switch on your Microrouter:

1) Check the RS232 machine lead is fitted securely between the serial

(COM) port socket on the machine controller PC and the RS232

socket, located on the righthand end panel of the Microrouter

cabinet.

2) When fitted, check the RS232 controller lead is fitted securely

between the serial (COM) port socket on the machine controller PC

and the RS232 socket on the DeskTop Tutor controller keypad.

3) Check that all access panels are in position and securely fastened.

4) Check that all inlet/exhaust vents are clear from obstructions.

5) Check the flexible hose from your separate dust collection vacuum

system is securely fitted to the connection hole, located on the

lefthand end panel of the Microrouter cabinet.

6) Plug the Microrouter mains supply cable into an available power

socket. Switch the power socket on.

7) The square, red, Microrouter on/off power switch is located on the

righthand end panel of the cabinet. Press the switch to the down

(on) position. The switch will illuminate when power is being

supplied to the electronic components.

Never attempt to access

the electronic hardware

systems of the machine

with the mains power

switched ON.

Note that hazardous

voltages can still exist

immediately after

switching off the power.

If the machine has

previously been

switched on, wait at

least 5 minutes before

attempting to open the

electrical panel access

plate.

Warning

Do not connect cables

between any electrical

hardware with the

mains power switched

on, since this could

seriously damage

components inside

your CNC machine.

Warning

If the Microrouter does not begin its power-up routine, switch off the

mains power supply to the CNC machine. Check all connections

and fuses, referring to Section 8 - Machine Electronics, if necessary.

8) Switch on the machine controller PC and start the CNC control

software. Establish a communication link with the Microrouter -

please refer to your separate CNC Control Software User’s Manual

for details outlining this procedure.

If a communication link cannot be established, recheck the

connections on the RS232 machine lead, followed by the

communication settings of your CNC control software, referring to

Section 9 - Technical Support, if necessary.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 93 94

Comentários a estes Manuais

Sem comentários

Compatible Systems MicroRouter 900i Manual do Utilizador Página 27

Comentários a estes Manuais

Manuais e produtos relacionados com Redes Compatible Systems MicroRouter 900i