Compatible Systems MicroRouter 900i Manual do Utilizador descarregar pdf (Página 28)

28 - CNC Machine Operation - Section 4 Microrouter CNC Machine User's Manual

4: Switching the Microrouter Off

Follow these instructions to switch off your Microrouter:

1) Wait for the Microrouter to fully complete any machining or

processing of any operational instructions.

2) Open the safety guard door and remove any finished parts from the

working area.

3) To close down the communication link between the Microrouter and

your PC, exit the CNC control software, as described in your

separate CNC Control Software User’s Manual.

4) To cut power to the Microrouter, press the square, red, Microrouter

on/off power switch to the up (off) position.

Note that cutting the machine power will trigger the closing of the

interlock guard switch. This will lock a closed safety guard door in

position, preventing access to the machine working area. The

interlock guard switch will automatically reopen when power is next

supplied to the Microrouter.

Never attempt to access

the electronic hardware

systems of the machine

with the mains power

switched ON.

Note that hazardous

voltages can still exist

immediately after

switching off the power.

If the machine has

previously been

switched on, wait at

least 5 minutes before

attempting to open the

electrical panel access

plate.

Warning

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 93 94

Sem comentários

Compatible Systems MicroRouter 900i Manual do Utilizador Página 28