Compatible-systems T1-10/100 Manual do Utilizador

Octal T1-10/100 RIOP Installation GuideCompatible Systems Corporation4730 Walnut StreetSuite 102Boulder, Colorado 80301303-444-9532800-356-0283http:

Chapter 2 - Quickstart Instructions 6WAN Interface ConfigurationThe default setting for all WAN interfaces on your Octal T1-10/100 RIOP is Off for all

Chapter 2 - Quickstart Instructions 7TB: Use configure and set either the RIPVersion keyword or the OSPFEnabled keyword in the IP WAN 0 (and/or any o

Chapter 2 - Quickstart Instructions 8TB: Use configure and then set the Mode and ConnectMode keywords in the Link Config WAN 0 (and/or any other port

Chapter 2 - Quickstart Instructions 9Box (under Global/IP Static Routes) to set static routes. OSPF and BGP can only be config-ured using text-based

Chapter 2 - Quickstart Instructions 10WAN interfaces which are set for Frame Relay operation do not need any additional parame-ters set in order to fu

Chapter 3 - Shipping Defaults 11Chapter 3 - Shipping DefaultsEthernet InterfaceIP Routing Defaults• On• Address: 198.41.12.1• Subnet Mask: 255.255.255

Chapter 3 - Shipping Defaults 12IPX Defaults• On• Unnumbered interfaceAppleTalk Defaults• On• Unnumbered interfaceDECnet Defaults• OffT1 CSU/DSU Defau

Chapter 4 - LED Patterns 13Chapter 4 - LED Patterns Some of the LEDs on the front of the VSR multigigabit switching router serve dual functions. In a

Chapter 4 - LED Patterns 14Octal T1-10/100 RIOP LED PatternsThe following LEDs and light patterns provide information about the Octal T1-10/100 RIOP i

Octal T1-10/100 RIOP Installation Guide, Version 1.0Copyright© 1999, Compatible Systems CorporationAll rights reserved. VSR, VSR-2, MicroRouter and

Table of ContentsiiiIntroduction to the Octal T1-10/100 RIOP 1Chapter 1 - Network Installation 2Connecting the Octal T1-10/100 to the Ethernet 2Connec

Table of ContentsivIP Protocol 8Required for IP Numbered Interface 8Required for IP Unnumbered Interface 8Suggested for IP 8IPX Protocol 9Required for

Introduction to the Octal T1-10/100 RIOP 1Introduction to the Octal T1-10/100 RIOP The Octal T1-10/100 Routing Input/Output Processor (RIOP), as part

Chapter 1 - Network Installation 2Chapter 1 - Network InstallationOctal T1-10/100 RIOP Front PanelThis section of the manual will help you install the

Chapter 1 - Network Installation 3v Note: The Octal T1-10/100 RIOP includes loopback features which can be used to check the functionality of your T

Chapter 2 - Quickstart Instructions 4Chapter 2 - Quickstart InstructionsThis Quickstart chapter briefly discusses the major parameters that must be se

Chapter 2 - Quickstart Instructions 5• IP static routesCV: Use the TCP/IP Routing: Ethernet 0 Dialog Box to set RIP, and the IP Static Routing Dialog